Dark Trenbolone Acetate Steroid Powder Canada Domestic Shipping

Are you looking for Dark Trenbolone Acetate Steroid Powder ? If you want to buy Dark Trenbolone Acetate Steroid Powder online , please feel free to contact us .Our tren ace powder has been exporting to many countries, such as USA,UK, CANADA,MEXICO,RUSSIA ,Competitive prices will be offered . Many people prefer Tren ace Powder with Dark color, Here is our latest batch of Trenbolone Acetate Powder ,do not hesiste to contact us ,buy legit Trenbolone Acetate Powder online, we are reliable steroid powder sources and we do super discreet packing to avoid the custom problems.

Raw trenbolone acetate powder is the main ingredients of injectable trenbolone acetate. Raw trenbolone acetate powder is yellow crystalline powder, CAS No. 10161-34-9, Molecular Formula: C20H24O3, Molecular Weight:312.4, Melt Point: 90- 92ºC, Storage Temp: 0-6°C.

Our tren ace powder has been exporting to many countries, such as USA,UK, CANADA,MEXICO,RUSSIA ,Competitive prices will be offered . Many people prefer Tren ace Powder with Dark color, Here is our latest batch of Trenbolone Acetate Powder

MAKE YOUR OWN Tren Acetate Gears

Tren Acetate 100mg/ml@50ml
5g Tren Acetate powder
1ml BA
10ml BB
35ml Grape seed oil

Trenbolone acetate homebrew step by step:

Step 1:
Weigh the steroid powder into the glass beaker as shown above, add the Benzyl Alcohol and Benzyl Benzoate

Step 2:
The solvents will begin immediately dissolving the powder but in order to speed the process up it is possible to use a water bath. Pace the vial into a few cm of water in a pan or something similar: it is important not to use water that is too hot because this will cause some products to oxidize-150f is a good temperature to use, alternatively boiled water from the kettle. The carrier oil should be the same temperature as the solution when it is added so if you warm the solution in a water bath you should also the same to the carrier oil. The objective at this point is simply to fully dissolved the powder into the solvents. There should be no “Hormone swirls” or any visible powder remaining in the solution and once this is achieved move on to the next step.

Step 3:
Add the warmed grape seed oil to the solution, this case 35ml must be added. Mix thoroughly again, there should be no hormone swirls-once this occurs remove immediately from the water bath and move on to the filtering process.
The steroid powder is fully dissolved in the solvents, the carrier oil is added and the product is ready to be filtered.

Step 4:
Draw up the solutions into the syringe you will be filtering with, this can be a single large syringe or this can be repeated multiple times with a smaller syringe. Remove the 0.22um sterile syringe filter from it’s packing and fix the green needle to the smaller side and then apply to the syringe.
Wipe the top of the sterile vial with an Alcohol swab and insert the green needle in it, put the needle attached to the syringe filter into the vial.

Pay attention: The second needle equalizes the pressure as the solution enters the vial. Apply pressure to the syringe plunger to the filter the mixture. This is the most important part of this entire process as it is what sterilizes your product. All finished steroids from any steroid lab must go through this very process.
Occasionally one may find that the filter gets blocked or that the process slows drastically-it is acceptable to replace the filter with a new one if this occurs to save time. The time it takes to filter steroids depends on which steroid is being filtered and how much is being filtere, as well as the mg/ml of the product.

发表评论